Plate shears – Plate Shear - Mechanical KAPEMA SMP 20-20

Τοποθεσία μηχανήματος

Κατασκευαστής

περιγραφή

sheet width 2050 mm
plate thickness 2 mm
strokes per minute until 38
cutting angle 1,75 ?
table height over floor 870 mm
total power requirement 3 kW
weight of the machine ca. 1520 kg
range L-W-H 2,2 x 0,6 x 1,2 m
The new motor guillotine type SMP is a well dimensioned machine with
all-welded link guides. The drive takes place with a
Standard geared brake motor via a chain connection to the main axle. the
Knives are of the highest quality. The optimal cutting angle secures the
Together with the rubber-covered blank holder perfect cuts.
Bearings and guides are maintenance and lubrication-free.
Standard equipment: ? Back gauge 665 with mm scale. ?
cutting edge lighting. ? Section counter. ? Table extensions 600 mm. ?
Right angle stop, left. ? Movable 24 V foot switch with emergency stop.
? Motor protection switch and emergency stop. ? 2 cutting edges per knife. ?
Rear protective grille, warranty = 12 months for single-shift operation.
Other models: 1275 x 3mm, 1250 x 4mm, 2050 x 2mm
Machine dealer with own stock of 1600 m?.
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.

Κατάσταση

Έτος κατασκευής

Machine under power