Overføringssystemer – Promot EPL without a KUKA robot

Maskinnr.

Beskrivelse

Reclining: 21 KVA
Control: Beckhoff
Nge: approx. 12000 mm
Stellpl ä tze: 12
(1200 x 1000 mm)
Component weight: 15 KG
Fl ä che:   12 x 5,5 x 4 m
Machine Description

Promot Automation with the following scope of delivery:
-  Portal Grundgesteep-boom portal
-  Tropttassen
-  Daugrease ration
-  Central Maintenance Unit
-protective door
oProtection grid system (wire mesh)
Robot Cell Basic Frame
-  Rost in a Soil Cup
-  cantilever sled
-  Portal Arm
  Pneumatic maintenance cutoff
Swivel drive (NC-controlled)
Parallel gripper 7
Special gripper finger for take-off unit set
Part attendance control
2 x pallet loading station (for 4 pallets each)
Wrap station
Out-of-the-turn slide
Raw substation station
Ready-to-finish station
Straightening Station
Tax cabinet Rittal
Handoperated KeTop T50
Additional Industrial PC
pPhone-Femdiagnosis for Beckhoff Control-via Modern
Robot control Kuka KRC
Signalleuke 3 Colors
Fliegendeworkpiece surveying-Interface Promot-Robot
gSoftware creation
Necessary hall height 5.000mm
power supply (standard, continuous operation) kVA 13-compressed air lanschlu ß cbm / 0,5

Run OP10
1. Portal: vertical pastry of pallet marked with OP 10
2. Place vertically in the base of the substation
3. Robot: unloading ready-to-use tell-place horizontally in the precast-part storage place
4. Robot: receptacle vertical blank from blank parking space -- Part length measurement-Beladen BAZ
I
5. Portal: receptacle finished part horizontally out of precast storage position-loading and unloading embossing station horizontal-transfer station Change from horizontal to vertical position-depositing in pallet in defined position to match the embossed part number
He
All of these processes are per part
2 x cross bolt through 75 x 100mm QB 100
62 x Cross-bolt diameter 75 x 280mm QB 280
8 x     transverse bolt through 75 x 316 mm QB 316
OP20 expiration
1 Portal: vertical part intake of pallet marked with OP20
2. Ablation in the vertical position of the raw part
3. Robot: load-off finished part-drop horizontally into the charging station washing station
4. Robots. Uptake of vertical unmachined part from blank deposit place-Ablegenhorizontalin straightening station -- radial alignment after cross-bores and force-locking alignment through high-coming bolts
n5. Robot. Aligned part in the clamping device and immediately span
Portal: recording of washed and lazy part horizontally from the
Washing machine -- Switching station Change from horizontal to vertical position-deposit in pallet in a defined position to match the embossed part number
I
All of these processes are per part
2 x cross bolt through 75 x 100mm QB 100
62 x Cross-bolt diameter 75 x 280mm QB 280
8 x     transverse bolt through 75 x 316 mm QB 316

(Technical data subject to reservation, as information provided by the manufacturer)

Keep in mind that the advertisement was translated automatically and may have errors. We are not responsible for these errors.

Delens tilstand

Maskin under kraft