Beskrivelse | sheet width 2030 mm
plate thickness 4,00 mm
thickness at "Niro-steel" 2,50 mm
no. of strokes 34 Hub / min
cutting angle 2,5 Grad
table height 820 mm
distance between columns 2340 mm
Control POS 100
back stop - adjustable max. 750 mm
engine output 6,8 kW
weight of the machine ca. 2860 kg.
range L-W-H 2870 x 2070 x 1400 mm
** Machine from a maintenance workshop
** very well maintained condition - hardly used (!!)
Furnishing:
- robust / motorized swing-cut guillotine shears
- Shatterproof, torsion-free steel welded construction
- compact and clear mechanical design
- Electric back gauge, with SCHR?DER POS 100 NC control
* Digital position display from the backgauge
* adjustable from the front right
* with target / actual value input
* Continuous adjustment over the entire travel range
* Protection of limit values with limit switches
* 9-fold programming possible
- "Duo-Cut" drive with two dynamic, powerful geared motors
- Support table with recessed grips
- Hold-down bar with hard rubber strip
- All-steel knife, double-edged
- 1x side stop, with T-slot and mm scale
- 2x extended sheet metal support arms, with T-slot and mm scale
- Selector switch for single and continuous stroke
- freely movable foot switch
- Rear safety device
- original operating instructions + CD Rom
**Special accessories included:
- pneumatically controlled sheet metal holding device for thin sheet metal cuts
* Sheet metal removal / sheet metal slide to the front (operator side)
- 1x wooden box with replacement scissor blades
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG. |
/uploadpic/tramaofinal_inserat/bilder/89138/bild1.jpg,/uploadpic/tramaofinal_inserat/bilder/89138/bild2.jpg,/uploadpic/tramaofinal_inserat/bilder/89138/bild3.jpg,/uploadpic/tramaofinal_inserat/bilder/89138/bild4.jpg,/uploadpic/tramaofinal_inserat/bilder/89138/bild5.jpg,/uploadpic/tramaofinal_inserat/bilder/89138/bild6.jpg
