Iron workers – Section Steel Shear GEKA Hydracrop 110 S

Produkt plats

Tillverkare

Beskrivning

28 min.
Punching force 110 to
40x20 mm
flat steel 600x15 oder 400x20 mm
L-beam 90? 160x160x16 mm
L-beam 45? 70x70x7 mm
50 mm
square edge steel 50 mm
13 mm
throat 300 mm
Basic equipment:
- Complete set of blades for flat steel shears
- Complete knife set for bar cutter
- Complete knife set for angle steel shears
- Compl. Standard punching device
- Stamp quick release device for punches up to 40 mm diameter
- Rectangle notch compl. with hold downs
- Complete knife set below for rectangular notching
- Upper tool for rectangular notching
- Support table for flat material
- Punching table with stop
- Notch with stop
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.

Condition

Byggår

Maskin under ström